Rigol DS1000CA series Guía de usuario descargar pdf (Pagina 25)

RIGOL

User‟s Guide for DS1000CA Series

1-13

To Understand the Horizontal System

See figure 1-9 as below, the HORIZONTAL Control Area contains a button and

two knobs, which are not only used to set up horizontal parameters and timebase,

but also to adjust horizontal position of waveforms.

Figure 1-9 Horizontal Control

1. The horizontal knob adjusts signal horizontal position on

waveform window.

Turning the horizontal knob, the waveform will move to left or

right and a sign at the left-bottom of the screen will vary to show the horizontal

position of the waveform.

Horizontal offset back to 0 shortcut key

Press the knob to set the horizontal offset to 0 as a shortcut

key, this is especially helpful when the trigger point is far out of the screen

and want it to get back to the screen center immediately.

2. Press MENU button to display “Time” menu, setting delayed state, time base

mode and trigger offset.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 145 146

Sin comentarios

Rigol DS1000CA series Guía de usuario Pagina 25