
RIGOL
User‟s Guide for DS1000CA Series
The Rear Panel
Figure 1-2
Rear panel of DS1000CA series oscilloscope
Interfaces:
Pass/Fail: It is used to output the pass/fail test result.
RS232: To connect the oscilloscope with external devices by serial port.
USB Device: It is used to connect DS1000CA with external USB devices when the
oscilloscope is regarded as a “Slave Device”. For example, connect with PC for
remote control.
Notation definitions in this User’s Guide:
Throughout this manual, notation symbols of buttons and knobs are the same of
those on front-panel.
A box around the name of the key denotes MENU function buttons on
front-panel, such as Measure.
( ) denotes the multi-function knob .
denotes the two POSITION knobs.
denotes the two SCALE knobs.
denotes the LEVEL knob.
The name with a drop shadow denotes the menu operating key, such as
Waveforms soft key in Storage menu.
Use “→” to divide operation steps. Such as: Storage → Storage, indicates press
“Storage” button on the front panel, then press “Storage” menu.
Pass/Fail RS232 USB Device
Comentarios a estos manuales