Rigol DS1000CA series Guía de usuario descargar pdf (Pagina 106)

RIGOL

User‟s Guide for DS1000CA Series

2-78

NOTE: The results of the automatic measurements will be displayed on the bottom

of the screen. Maximum 3 results could be displayed at the same time. When there

is no room, the next new measurement result will make the previous results moving

left out of screen.

Operation Explanation:

1. Select the signal channel for measuring. CH1 or CH2 according to the signal of

interest.

Press soft buttons as follows: Measure→Source→CH1 or CH2.

2. To see all measurement values, set the Display All to ON. 18 measurement

parameters will be displayed on the screen (except for “Delay1→2 ” and

“Delay1→2 ” ).

3. Select parameters page for measuring; select voltage or time parameters pages

by pressing soft button as follows: Measure→Voltage or time →Vmax, Vmin……

4. To get the measured value on the screen; select the parameters of interest by

pressing the soft button on the right of the menu, and read the data on the

bottom of the screen.

If the data is displayed as “*****”, it means the parameter cannot be measured

in current condition.

5. Clear the measure values: press Clear and all of the auto measure values would

disappear from the screen (except for “Display all” parameters).

Figure 2-111 Measure menu

Turn on/off the mass measurement

Clear measured data from screen

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 145 146

Sin comentarios

Rigol DS1000CA series Guía de usuario Pagina 106