
RIGOL
User‟s Guide for DS1000CA Series
Function Check
Perform this quick functional check to verify that the instrument is operating
correctly.
1. Turn on the instrument
Use the power cord designed for the oscilloscope to connect the instrument and
AC power which delivers 100 to 240 VAC
RMS
, 45Hz to 440Hz. Press the power
switch to turn on the instruments, waiting until the display shows the waveform
window.
2. Recall factory setting
Press Storage → Storage → Factory → Load, to recall factory setting.
Figure 1-4
Turn on the instrument
WARNNING
To avoid electric shock, be sure the oscilloscope is properly grounded.
3. Input a signal to a channel of the oscilloscope
Push BNC plug of probe into CH1 BNC connector, then twist the BNC cable to
right to lock the probe in place. Switch on the probe to 10X.
Power Switch Storage Button
Comentarios a estos manuales