Rigol DS1000MD Especificaciones descargar pdf (Pagina 41)

Chapter 4 Calibration RIGOL

Service Guide for DS1000E, DS1000D Series

4-1

Chapter 4 Calibration

The oscilloscope can achieve the optimum state fleetly by performing the calibration

program and get accurate measurement. You can execute the calibration at any time.

But when the operating temperature changes up to or more than 5℃, you must

perform this programme.

NOTE:

The oscilloscope must have been working or warm-up at least 30-minutes before

running self-calibration to get best accuracy.

Steps：

1. Disconnect any probes or cables from all channel inputs, otherwise failure or

damage to the oscilloscope may occur.

2. Press Utility→Self-Cal, enter the Self-Calibration interface.

Figure 4-1 Self-Calibration interface

3. Press RUN/STOP to start the Self-Calibration, the oscilloscope will calibrate the

vertical system (CH1, CH2 and Ext), horizontal system and the trigger system

automatically to guarantee the specifications in different environment.

4. The screen will give a message of “Calibration finished” after finish the calibration

and you can press RUN/STOP to exit.

Figure 4-2 Finish Self-Calibration

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 62 63

Sin comentarios

Rigol DS1000MD Especificaciones Pagina 41