Rigol DS1000M Guía de usuario descargar pdf (Pagina 37)

RIGOL

User’s Guide for DS1000 Series

3. Probe Attenuation Setting

When using a probe, the oscilloscope allows you to select the attenuation factor for

the probe. The attenuation factor changes the vertical scaling of the oscilloscope so

that the measurement results reflect the actual voltage levels at the probe tip.

To change (or check) the probe attenuation setting, press the CH1 or CH2 button

(according to which channel you are using), toggle the Probe soft button to change

the attenuation factor to match the probe you are using.

This setting remains in effect until changed again.

Figure 2-8 gives an example for using a 1000:1 probe and its attenuation factor.

Figure 2-8

Tab l e 2- 3

Probe attenuation

factors

Corresponding settings

1:1 1X

10:1 10X

100:1 100X

1000:1 1000X

Probe

attenuation

Vertical volt/div.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 167 168

Sin comentarios

Rigol DS1000M Guía de usuario Pagina 37