Rigol DS1000M Guía de usuario descargar pdf (Pagina 125)

RIGOL

User’s Guide for DS1000 Series

Using Automatic Measurement as the following steps demonstrate:

1. Select the signal channel for measuring. You could select CH1 or CH2 according

to the signal you are interested in.

Press soft buttons as follows: Measure→Source→CH1 or CH2.

2. To see all measurement value, set the Display All to ON. 18 measurement

parameters will be displayed on the screen.

3. Select parameters page for measuring. You could select voltage or time

parameters pages by pressing soft button as follows: Measure→Voltage or time

→Vmax, Vmin……

4. To get the measured value on the screen. You could select the parameters you

are interested in by pressing the soft button on the right of the menu, and read

the data on the bottom of the screen.

If the data is displayed as “*****”, it means the parameter cannot be measured

in current condition.

5. Clear the measure values: press Clear. Now, all of the auto measure values

disappear from the screen.

Figure 2-116

Turn on/off the mass measurement

Clear measured data from screen

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 167 168

Sin comentarios

Rigol DS1000M Guía de usuario Pagina 125