Rigol DS1000M Guía de usuario descargar pdf (Pagina 155)

RIGOL

User’s Guide for DS1000 Series

Troubleshooting

1. After the oscilloscopes is powered on, the screen remains dark, please

inspect the instrument following these steps:

(1) Check the power cable’s connection

(2) Ensure the power switch is turned on

(3) After the inspections above, restart the oscilloscope

(4) If the problem still remains, please contact RIGOL for help

2. After the signal acquisition the waveform does not appear, please

check according to the following steps:

(1) Check the probes connected with the signals

(2) Check the probes connected to the channels firmly

(3) Check the probes connected with the object being tested.

(4) Check the circuit generates signal on the test point

(5) Repeat the acquisition

3. The measurement result is 10 times higher or lower than the value

expected.

Check if the probe attenuation is the same as the channel attenuation.

4. if the oscilloscope does not get a stable waveform display, please check

according to the following steps:

(1) Check the Trigger Source and notice if it is set to the channel you use

(2) Check the Trigger Type. You should use “Edge” for normal signals, and use

“Video” for VIDEO signals.

(3) Switch the coupling into HF Rejection or LF Rejection in order to filter the noise

which disturbs trigger.

5. After pressing the RUN/STOP button, the oscilloscope does not display

any waveform on screen.

Check whether the Trigger Mode is set to “Normal” or “Single” and see whether

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 167 168

Sin comentarios

Rigol DS1000M Guía de usuario Pagina 155