Rigol MSO/DS2000A Series Manual de usuario descargar pdf (Pagina 44)

RIGOL Chapter 1 Quick Start

1-16 MSO2000A/DS2000A User’s Guide

CLEAR

Press this key to clear all the waveforms on the screen. If

the oscilloscope is in the “RUN” state, new waveforms

will still be displayed.

RUN/STOP

Press this key to set the state of the oscilloscope to

“RUN” or “STOP”.

In the “RUN” state, the key is illuminated in yellow.

In the “STOP” state, the key is illuminated in red.

SINGLE

Press this key to set the trigger mode to “Single” and this

key is illuminated in orange. In single trigger mode, press

FORCE to generate a trigger signal immediately.

AUTO

Press this key to enable the waveform auto setting

function. The oscilloscope will automatically adjust the

vertical scale, horizontal time base and trigger mode

according to the input signal to realize optimum

waveform display.

Note: Auto setting requires that the frequency of the

signal under test should be no lower than 20Hz if the

signal under test is Sine. Otherwise, the waveform auto

setting function may be invalid and the quick parameter

measurement function displayed in the menu will also be

unavailable.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 316 317

Sin comentarios

Rigol MSO/DS2000A Series Manual de usuario Pagina 44