Rigol MSO/DS2000A Series Manual de usuario descargar pdf (Pagina 106)

RIGOL Chapter 5 To Trigger the Oscilloscope

5-20 MSO2000A/DS2000A User’s Guide

Slope Trigger

Trigger on the positive or negative slope which satisfies the specified condition.

Trigger Type:

Press Type, rotate to select “Slope” and press down . At this point, the

trigger setting information is displayed at the upper right corner of the screen. For

example,

. The trigger type is slope trigger; the trigger source is

CH1; the difference between the upper limit of trigger level and the lower limit of

trigger level is 1.24 V.

Source Selection:

Press Source to switch the signal source list between CH1 and CH2. For the details,

please refer to the introduction in “

Trigger Source”. The current trigger source is

displayed at the upper right corner of the screen.

Note: Select channel with signal input as trigger source to obtain stable trigger.

Slope Condition:

In this oscilloscope, positive slope time is defined as the time difference between the

two crossing points of trigger level line A and B with the rising edge; negative slope

time is defined as the time difference between the two crossing points of trigger level

line A and B with the falling edge as shown in the figure below.

Figure 5-6 Positive Slope Time/Negative Slope Time

Press When to select the desired slope condition.

 : trigger when the positive slope time of the input signal is greater than

the specified time.



: trigger when the positive slope time of the input signal is lower than the

specified time.



: trigger when the positive slope time of the input signal is greater than

the specified lower limit of time and lower than the specified upper limit of time.

Up Level

Low Level

Positive Slope Time

Negative Slope Time

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 316 317

Sin comentarios

Rigol MSO/DS2000A Series Manual de usuario Pagina 106