Rigol MSO/DS2000A Series Manual de usuario descargar pdf (Pagina 167)

Chapter 6 MATH and Measurements RIGOL

MSO2000A/DS2000A User’s Guide 6-31

namely do not use cursor A or cursor B.

2. Adjust Cursor Position

 Adjust cursor A: press CursorA and use to adjust the position of cursor

A. During the adjustment, the measurement result will change accordingly.

The adjustable range is limited within the screen.

 Adjust cursor B: press CursorB and use to adjust the position of cursor

B. During the adjustment, the measurement result will change accordingly.

The adjustable range is limited within the screen.

 Adjust cursor A and B at the same time: press CursorAB and use to

adjust the position of cursor A and B at the same time. During the

adjustment, the measurement results will change accordingly. The

adjustable range is limited within the screen.

Note:

 Under the current menu, you can press continuously to select CursorA,

CursorB and CursorAB.

 When “None” is selected as the measurement source of cursor A (or cursor

B), CursorA (or CursorB) and CursorAB will be grayed out.

 In track mode, the cursor will track the marked point (namely jumps up and

down with the transient change of the waveform). Thus, the Y value might

change even though you do not adjust the cursor.

3. Measurement Example

Use cursor A and B to measure the waveforms of CH1 and CH2 respectively. You

would discover that the cursors would track the marked points when the

waveforms are expanded or compressed horizontally, as shown in Figure 6-9

and Figure 6-10.

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 316 317

Sin comentarios

Rigol MSO/DS2000A Series Manual de usuario Pagina 167