Rigol DS1000E series Guía de usuario descargar pdf (Pagina 99)

RIGOL

User’s Guide for DS1000E, DS1000D Series

2-71

Pass/Fail

The Pass/Fail function monitors changes of signals and output pass or fail signals by

comparing the input signal that is within the pre-defined mask. The testing results

not only can be displayed on screen or output by isolated pass/fail port but also can

be alarmed if turn on system sound.

Press Utility→Pass/Fail to go to the following menu.

Figure 2- 94 Table 2- 58 The Pass/Fail Menu (Page 1/2)

Setting

Comments

Enable Test

OFF

Turn on Pass/Fail test

Turn off Pass/Fail test

Source

CH1

CH2

Select Pass/Fail test on CH1

Select Pass/Fail test on CH2

Operate

(RUN)

■ (STOP)

Pass/Fail test stopped, press to run

Pass/Fail test running, press to stop

Msg display

OFF

Turn on Pass/Fail information

display

Turn off Pass/Fail information

display

Figure 2- 95 Table 2- 59 The Pass/Fail Menu (Page 2/2)

Settings

Comments

Output

Fail

Fail +

[1]

Pass

Pass+

Output when Fail condition

detected.

Output and beep when Fail

condition detected.

Output when Pass condition

detected.

Output and beep when Pass

condition detected.

Stop

on Output

OFF

Stop test when output occur

Continue test when output occur

Mask Setting

Go to mask setting menu

NOTE

[1]

: The beeper should be opened.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 161 162

Comentarios a estos manuales

Sin comentarios

Rigol DS1000E series Guía de usuario Pagina 99

Comentarios a estos manuales