Rigol DSA875 Manual de usuario Pagina 201
- Pagina / 235
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 4 Troubleshooting&Message RIGOL
User’s Guide for DSA800 Series
4-9
Error Message
Command Error
Number
Message Description
-100
Command error.
A generic syntax error indicates that the device cannot detect more
specific errors. This code indicates that only Command Error defined in
IEEE 488.2,11.5.1.1.4 has been found.
-101 Invalid character.
The syntactic element contains an invalid character; for example, the
command header contains an ampersand (SETUP&). This error might
be used in place of errors -114, -121, -141 and perhaps some others.
-102 Syntax error.
An unrecognizable command or data type was encountered; for
example, a string not supported by the device was received.
-103 Invalid separator.
The parser was expecting a separator but recieved an illegal character;
for example, the semicolon following a program message was omitted:
*EMC 1:CH1:VOLTS 5.
-104
Data type error.
The parser recognized a data element other than the one allowed; for
example, numeric or string data was expected but block data was
encountered.
-105 GET not allowed.
A Group Execute Trigger was contained in a program message (see
IEEE 488.2, 7.7).
-108 Parameter not allowed.
More parameters were received than expected for the command
header; for example, the *EMC common command only accepts one
parameter, so *EMC 0, 1 is not allowed.
-109 Missing parameter.
Fewer parameters were contained than required in the command
header; for example, the *EMC common command requires one
parameter, so *EMC is not allowed.
-110
Command header error.
- User’s Guide 1
- DSA800 Series 1
- Spectrum Analyzer 1
- Guaranty and Declaration 3
- Safety Requirement 4
- Safety Terms and Symbols 7
- General Care and Cleaning 12
- Environmental Considerations 13
- DSA800 Series Overview 14
- Document Overview 15
- Contents 17
- RIGOL Contents 18
- Contents RIGOL 19
- Chapter 1 Quick Start 21
- General Inspection 22
- Appearance and Dimensions 23
- To Prepare for Use 24
- To Connect to Power 25
- Power-on Inspection 26
- Self-calibration 26
- To Set the System Language 26
- Front Panel 27
- Front Panel Function Keys 28
- Front Panel Key Backlight 30
- Front Panel Connectors 31
- RIGOL Chapter 1 Quick Start 32
- To Use the Numeric Keyboard 33
- Rear Panel 35
- User Interface 37
- Chapter 1 Quick Start RIGOL 39
- Menu Operation 40
- Parameter Setting 42
- To Input Filename 44
- To Use the Built-in Help 48
- To Use the Security Lock 50
- To Replace the Fuse 51
- Basic Settings 54
- Center Freq 55
- Start Freq 55
- Stop Freq 56
- Freq Offset 57
- CF Step 58
- Signal Track 58
- Peak -> CF 60
- CF -> Step 61
- Full Span 62
- Zero Span 62
- Zoom In 63
- Zoom Out 63
- Last Span 63
- X Scale (Only for DSA815) 63
- Auto Scale 64
- Ref Level 65
- Input Atten 66
- Scale/Div 66
- Scale Type 67
- Units 68
- Ref Offset 68
- Auto Range 69
- RF Preamp 71
- Correction 72
- MaxMixL 74
- Input Impedance 74
- Sweep and Function Settings 75
- V/R Ratio 76
- Detector Type 77
- Filter Type 79
- Sweep/Trig 80
- Auto SWT 81
- Numbers 83
- Trig Type 84
- Trig Setup 84
- Trace/P/F 86
- Average Times 87
- Trace Math 88
- Blank All 89
- Pass/Fail 89
- Average Reset 92
- TG Level 93
- TG Lvl Offset 94
- Normalize 96
- Measurement Settings 98
- Restart 100
- Meas Mode 101
- Meas Setup 102
- T-Power 105
- Chan Pwr 111
- C/N Ratio 120
- /N Ratio Measurement 121
- Frequency/100, the 121
- Harmo Dist 123
- Demod Setup 128
- Marker Measurements 130
- Select Mkr 131
- Normal 131
- Delta Pair 133
- Span Pair 133
- Mkr Trace 134
- Readout 134
- Mkr Table 135
- All Off 136
- Marker-> 137
- Mkr->Stop 138
- Mkr->Ref 138
- MkrΔ->CF 138
- MkrΔ->Span 138
- Marker Fctn 139
- Function Off 140
- Freq Count 141
- Next Peak 142
- Peak Right 142
- Peak Left 142
- Min Search 143
- Peak Peak 143
- Cont Peak 143
- Search Para 143
- Peak Table 144
- Shortcut Key 146
- User Key 148
- System Settings 156
- Calibrate 157
- I/O Settings 158
- Display 161
- Work Setting 163
- Coupl Param 163
- Information 164
- Self-Test 165
- Time/Date 165
- License 166
- TX1000 (Option) 167
- Sanitation 168
- Print Setup 169
- Storage 172
- File Type 173
- File Sourse 174
- Browser 175
- Expand Dir 175
- Collapse Dir 175
- Create Dir 177
- Disk Info 177
- Name Prefix 178
- System Update 178
- Chapter 3 Remote Control 179
- Remote Control Overview 180
- Remote Control Method 181
- To Use PC software 184
- Troubleshooting 194
- Messages 196
- Information Message 198
- Error Message 201
- Execution Error 205
- Device Specific Error 208
- Query Error 213
- Status Message 214
- Chapter 5 Specifications 215
- Technical Specifications* 216
- DSA815 DSA832 DSA875 217
- Amplitude 218
- Tracking Generator (Option) 224
- Trigger 224
- Input /Output 225
- General Specifications 226
- Chapter 6 Appendix 229
- RIGOL Chapter 6 Appendix 230
- Appendix B: Warranty 231
- Index RIGOL 233
- RIGOL Index 234
- ................. 2-16 235
© 2020, manymanuals.es. Todos los derechos reservados | 0.027 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales