Rigol DS1000B Manual de usuario descargar pdf (Pagina 20)

RIGOL

User’s Guide for DS1000B series

1-8

Figure 1-5 Probe connection Figure 1-6 Probe adjustment

[1]

 Attach the probe tip to the Probe compensator connector and the reference lead

to the ground pin. Press Auto, within a few seconds, a square wave will display

(approximately 1kHz, 3Vpp).

 Push the OFF button or push the CH1 button again to turn off Channel 1. Push

the CH2, CH3, CH4 buttons to turn on other channels, repeat step 2&3.

NOTE: Signal outputed from the Probe compensator is ONLY used for probe

compensation, not for calibration.

Note:

[1] For DS1204B, the standard probe is RP3300A which attenuation ratio is fixed at 10X and does

not need to be adjusted.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 165 166

Sin comentarios

Rigol DS1000B Manual de usuario Pagina 20